Protect against abrasion in the toughest environments – dumpsters, commercial kitchen floors and walls, industrial plants - EonCoat abrasion resistant coatings are more abrasion resistant that epoxies and used alone or as a protective prime coat.
EonCoat is a true ceramic coating and like most ceramics, it provides a very hard surface that does not scratch easily. Abrasion tests conducted on a Taber machine, using an abrasive wheel rotating against a coated panel show that the number of cycles to get .001” wear for most polymer paints is about 75 cycles, and for an ordinary epoxy it is about 125-250 cycles. To get the same amount of wear in EonCoat it takes 1000 cycles.
| Coating: | Cycles on Taber to Achieve 1 mil of Wear |
| Most Paints / Coatings | 75 Cycles |
| Epoxy Coatings | 125-250 Cycles |
| EonCoat | 1000 Cycles |
EonCoat coatings create a ceramic encapsulation so abrasion resistant that it is extraordinarily difficult, if not impossible, for water, oxygen, or harsh chemicals to make intrusions into the substrate. Using EonCoat enables you to extend the life of your substrate or products by several orders of magnitude.
EonCoat protects against abrasion in harsh environments that damage other coatings. Where other coatings yield a poor appearance and expose the substrate to further damage by exposing it to water intrusion and corrosion, EonCoat protects and extends the life of the substrate.
Corrosion resistant and abrasion resistant are two of the protective properties of EonCoat. EonCoat is also an excellent protective barrier against chemical spills and is a superior flame barrier.
